Toyota — Service Manual Change History

19-108 19-108 Electrical System Troubleshooting Click here for more info on 73-1 code z Error code 73-1 (Knob position compensation solenoid abnormality) Related portion O4 A20 AO1 Knob position compensation solenoid SAS/OPS controller Probable cause c Connector contact defect d Harness defect e Knob position compensation solenoid defect f SAS/OPS controller defect Error code 73-1 Connector contact defect Harness defect Knob position compensation solenoid defect SAS/OPS controller defect *: Make sure that no error is displayed when turning the knob position compensation solenoid ON/OFF using the active test function. Inspection 1: Inspect for continuity and short circuiting of the harness.

Ignition key switch OFF, disconnect O4 and A20 Standard: Section 19 C 9 (E02) 19 E TAB 2 8 (E01) R Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of O4, AO1 and A20, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine) and check whether or not there is an error.* No error Error Inspection 1: Harness continuity and short circuit inspection OK Inspection 2: Knob position compensation solenoid individual inspection OK A20-6 ~ O4-1 Continuity O4-2 ~ Frame Continuity A20-8 ~ Frame Continuity A20-9 ~ Frame Continuity A20-6 ~ Frame No continuity