19-117 Electrical System Troubleshooting z Error codes AD-1, AD-2, AD-7, AD-8 (ASC spec.) (CAN communication abnormality) Related portion 8 (BATT) A21 ECU-B 1 (IG1) ECU-IG AQ1 Q2 SAS/OPS controller Multi-function display AG2 G39 4 5 IGN 1 ASC controller G38 ECU-B2 1 Probable cause c Connector contact defect g Engine controller defect d Engine controller harness defect h Multifunction display defect e Multifunction display harness defect i SAS/OPS controller defect f Fuse defect Caution: When the controller or optional display is replaced into another vehicle with different specifications, AD-1 and AD-7 may occur. In such cases, perform "Engine and display ECU information clear".
Error codes AD-1, AD-2, AD-7, AD-8 Fuse defect Connector contact defect Harness defect Engine controller defect (AD-1) Multifunction display defect (AD-7) SAS/OPS controller defect (AD-8) SAS/OPS controller or engine controller defect (AD-2) Section 19 C B 5 (CANH) 13 (CANL) 4 RE TA 6 (CANL) 3 (E1) C B 26 (CANL) RE TA 25 (IGSW) Disconnect the negative terminal of the battery and inspect the fuses.
NG OK Disconnect the battery negative terminal (for more than 10 seconds), after inspecting and correcting disconnection and water entry of A20, A21, G38, G39, AQ1, AG2 and Q2, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON and check whether or not there is an error.* Error Inspection 1: Harness continuity and short circuit inspection OK