Toyota — Service Manual Change History

19-120 19-120 Electrical System Troubleshooting z Error codes C4-1, C4-2, C4-3, C4-4, C4-5, C4-6 (4Y-E spec.) (Accelerator sensor abnormality) Related portion A35 a1 Aa1 Probable cause c Connector contact defect d Accelerator sensor defect e Harness defect f Engine controller defect Error codes C4-1, C4-2, C4-3, C4-4, C4-5 Connector contact defect Accelerator sensor defect Harness defect Engine controller defect *: Make sure that no error code is displayed when the accelerator pedal is operated.

Section 19 Engine controller 25 (VCPA) 4 5 (VCP1) 26 (VPA) 8 4 (VPA1) 27 (EPA) 2 6 (EP1) REC TAB 33 (VCP2) 3 1 (VCP2) 34 (VPA2) 7 3 (VPA2) 35 (EPA2) 1 2 (EPA2) Accelerator sensor 26 (VPA) 8 4 (VPA1) 27 (EPA) 2 C 6 (EP1) 33 (VCP2) 3 E TAB 1 (VCP2) 34 (VPA2) 7 R 3 (VPA2) 35 (EPA2) 1 2 (EPA2) Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A35, Aa1 and a1, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine), and check whether or not there is an error.* No error Error Inspection 1: Accelerator sensor individual inspection OK Inspection 2:

Harness continuity and short circuit inspection OK