Toyota — Service Manual Change History

19-127 Electrical System Troubleshooting Error code C7-1 Connector contact defect Shift switch defect Harness defect *: Check if an error occurs after turning the ignition key switch ON, moving the shift lever and traveling from stopped state to more than 10 km/h (6.2 mph) within 3 seconds. SAS/OPS controller defect Error code C7-2 Connector contact defect Shift switch defect Harness defect SAS/OPS controller defect *: Make sure there is no error after turning the ignition key switch ON, and move the shift lever to forward and reverse travel.

Section 19 Disconnect the battery negative terminal, after inspecting and correcting disconnection of A20 and A41 and internal moisture, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine) and check whether or not there is an error.* No error Error Inspection 1: Check the condition of the switch ANL.: I/O TRAVELING 2/3 NG Inspection 2: Individual continuity inspection of the direction lever switch that was abnormal in inspection 1 (while still installed on the vehicle). OK Inspection 3:

Harness continuity and short circuit inspection OK Disconnect the battery negative terminal, after inspecting and correcting disconnection of A20 and A41 and internal moisture, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (start the engine) and check whether or not there is an error.* No error Error Inspection 4: Check the condition of the switch ANL.: I/O TRAVELING 2/3 NG Inspection 3: Harness continuity and short circuit inspection NG