19-129 Electrical System Troubleshooting z Error code CA-1 (Forward-reverse travel lever abnormality) Related portion Probable cause c Connector contact defect f Reverse travel relay harness defect d Forward travel relay harness defect g Reverse travel relay defect e Forward travel relay defect h SAS/OPS controller defect Error code CA-1 Connector contact defect Harness defect Relay defect SAS/OPS controller defect Inspection 1: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A20, A21 and forward/reverse relay Standard:
Section 19 SAS/OPS controller A21 17 (RYF) 1 Forward travel A20 2 relay 8 (E01) 9 (E02) 1 Reverse travel 2 relay Reverse travel relay Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A20 and A21, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON and check whether or not there is an error. No error Error Inspection 1: Harness continuity and short circuit inspection OK Inspection 2: Relay individual inspection OK A21-17 ~ R/B forward relay terminal 1 Continuity R/B reverse relay terminal 2 ~ Frame Continuity A20-9 ~ Frame Continuity A20-8 ~ Frame Continuity A21-17 ~ Frame No continuity