19-133 Electrical System Troubleshooting z Error codes F1-1, F2-1 (Controller to combination meter communication abnormality) Related portion A20 QA1 Q1 Probable cause c Connector contact defect d Hour meter harness defect e Hour meter defect f SAS/OPS controller defect Error codes F1-1, F2-1 Connector contact defect Combination meter defect Harness defect SAS/OPS controller or combination meter defect Inspection 1: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A20 and Q1 Standard:
Section 19 SAS/OPS controller 14 (SIL) 10 3 (SIL2) TAB REC Combination meter B C TA RE Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A20, QA1 and Q1, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON and check whether or not there is an error. No error F1-1 Inspection 1: Harness continuity and short circuit inspection OK Q1-3 ~ Frame No continuity A20-14 ~ Q1-3 Continuity