Toyota — Service Manual Change History

19-142 19-142 Electrical System Troubleshooting Error codes H3-1, H3-2, H3-3, H3-4 Disconnect the battery negative terminal, after inspecting and correcting disconnect and water entry of A21, A23, AO3, XO2, YX1 and Y2, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON, and check whether or not there is an error. Error None Connector contact defect Error Turn the ignition key switch OFF, disconnect the battery negative terminal, replace the attachment 1 lever potentiometer with the tilt lever potentiometer, and check if there is any change in the error. H2-4 Inspection 1:

Attachment 1 lever potentiometer inspection NG Installation defect OK H3-* Attachment 1 lever potentiometer abnormality H2-1·H2-2·H2-3 Inspection 2: Harness continuity and short circuit inspection NG Harness defect OK Fuse inspection Replace fuse NG OK SAS/OPS/mini lever controller defect Note: If the lever has been removed, be sure to perform matching after the lever is reinstalled. Inspection 1: Carry out attachment 1 lever potentiometer inspection.

Ignition key switch OFF, return the attachment 1 lever potentiometer and tilt lever potentiometer to their original positions Check attachment 1 lever potentiometer installation (refer to section 18), ignition key switch ON, match attachment 1 lever potentiometer Section 19