19-147 Electrical System Troubleshooting z Error codes H5-1 and H5-2 (Lift solenoid abnormality) Related portion A23 A51 Probable cause c Connector contact defect f Lift PULL solenoid harness defect d Lift PUSH solenoid harness defect g Lift PULL solenoid defect e Lift PUSH solenoid defect h SAS/OPS/mini lever controller defect Error codes H5-1, H5-2 H5-1 is now described. For H5-2, substitute A52 for A51 and PULL for PUSH in the following. Connector contact defect Lift PUSH solenoid defect Harness defect SAS/OPS mini lever controller defect Inspection 1: Carry out lift solenoid individual inspection.
4 3 2 1 8 7 6 5 Ignition key switch OFF, disconnect battery negative terminal, disconnect A51 Standard: (Solenoid side) A51 Section 19 SAS/OPS/ mini lever controller 17 (LSO+) 5 (LDS+) Lift PUSH 18 (LPSH) 1 (LDS-) solenoid A52 5 (LUS+) Lift PULL 19 (LPLL) 1 (LUS-) solenoid Lift PUSH solenoid Lift PULL solenoid Disconnect the battery negative terminal, after inspecting and correcting disconnect and water entry of A23 and A51, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON, operate the lift lever and check whether or not there is an error. No error Error Inspection 1: Lift solenoid individual inspection OK Inspection 2:
Harness continuity and short circuit inspection OK A51-5 ~ A51-1 Approx. 7 Ω (20°C)