19-149 Electrical System Troubleshooting z Error codes H6-1 and H6-2 (Tilt solenoid abnormality) Related portion A23 A51 Probable cause c Connector contact defect f Tilt PULL solenoid harness defect d Tilt PUSH solenoid harness defect g Tilt PULL solenoid defect e Tilt PUSH solenoid defect h SAS/OPS/mini lever controller defect Error codes H6-1 and H6-2 H6-1 is now described. For H6-2, substitute A52 for A51 and PULL for PUSH in the following Connector contact defect Tilt PUSH solenoid defect Harness defect SAS/OPS mini lever controller defect Inspection 1: Carry out tilt solenoid individual inspection. 4 3 2 1 8 7 6 5 Ignition key switch OFF, disconnect A51 Standard:
(Solenoid side) A51 Section 19 SAS/OPS/ mini lever controller 1 (TSO+) 6 (TFS+) Tilt PUSH 2 (TPSH) 2 (TFS-) solenoid A52 6 (TRS+) Tilt PULL 3 (TPLL) 2 (TRS-) solenoid Tilt PUSH solenoid Tilt PULL solenoid Disconnect the battery negative terminal, after inspecting and correcting disconnect A23 and A51 and water entry, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON, operate the tilt lever and check whether or not there is an error. No error Error Inspection 1: Tilt solenoid individual inspection OK Inspection 2: Harness continuity and short circuit inspection OK A51-6 ~ A51-2 Approx. 7 Ω (20°C)