Toyota — Service Manual Change History

19-151 Electrical System Troubleshooting z Error codes H7-1, H7-2 (Attachment 1 solenoid abnormality) Related portion A23 A51 Probable cause c Connector contact defect d Attachment 1 PUSH solenoid harness defect e Attachment 1 PUSH solenoid defect f Attachment 1 PULL solenoid harness defect g Attachment 1 PULL solenoid defect h SAS/OPS/ mini lever controller defect Error codes H7-1, H7-2 H7-1 is now described.

For H7-2, substitute A52 for A51 and PULL for PUSH in the following Connector contact defect Attachment 1 PUSH solenoid defect Harness defect SAS/OPS mini lever controller defect Section 19 SAS/OPS/ mini lever controller 20 (3SO+) 7 (3FS+) Attachment 1 21 (3PSH) 3 (3FS-) PUSH solenoid A52 7 (3RS+) Attachment 1 22 (3PLL) 3 (3RS-) PULL solenoid Attachment 1 PUSH solenoid Attachment 1 PULL solenoid Disconnect the battery negative terminal, after inspecting and correcting disconnect and water entry of A23 and A51, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON, operate attachment lever 1 and check whether or not there is an error.

No error Error Inspection 1: Attachment 1 solenoid individual inspection OK Inspection 2: Harness continuity and short circuit inspection OK