Toyota — Service Manual Change History

19-165 Electrical System Troubleshooting Section 19 Corrective action Harness check or replace switch Change Replace Change Replace Harness check or replace buzzer Replace Harness check or replace buzzer Change Replace *: Only export model except “WITHOUT OPS BUZZER” specification Checking method ON/OFF check with analyzer Check the setting content of the maximum speed limiter, check the setting content of the speed limit setting. – Check the setting content of the maximum speed limiter, check the setting content of the speed limit setting. – – – – Check setting values with option set – Malfunction area · mode Lifting height switch unit:

Disconnection fault (Internal damage, stuck) Display setting: Maximum speed limiter, speed limiter setting enabled SAS/OPS/mini lever controller: Controller defect Display setting: Maximum speed limiter, speed limiter setting enabled SAS/OPS controller: Controller defect Buzzer unit: Buzzer defect Buzzer harness line (Lead-in side): Ground short or link fault (Harness, connector) SAS/OPS controller: Controller defect Buzzer unit: Buzzer defect Buzzer harness line (Power supply side, lead-in side): Disconnection fault (Harness, connector) Display setting: OPS leaving seat notification buzzer setting disabled SAS/OPS controller, OPS controller:

Controller defect Phenomenon on vehicle For vehicles with travel and load handling control: Speed limit applies when loaded despite being at a low lifting height For vehicles with travel and load handling control: Speed limit applies at all times regardless of lifting height or load Buzzer sounds constantly OPS leaving seat warning does not sound. Control type Travel and load handling control Buzzer related (*)