SIB CC08-005 4Y-ECS Controller Programming Change Page 2 of 2 REPAIR INFORMATION: To change out the ECS controller: 1. Disconnect the battery. 2. Replace the ECS controller. 3. Reconnect the battery. 4. Once the controller is replaced. Verify that the ignition timing and fuel system are adjusted correctly. Ignition Timing and Fuel System Adjustments: To check and adjust the ignition timing, reference page 2-18 of the 8-Series repair manual, 00700-X8880-71. TNB-2008-07 can be used as a reference and guide line for checking and making the adjustments to the fuel system. The idle mixture adjustment screw can be accessed by piercing the cap and prying it out of the sleeve.
Use a pick to pierce and pry out the cap for the idle Mixture adjustment screw Be sure the replace the tamper resistant cap, p/n 21673-13370-71, after making the any adjustments to the regulator. This is an EPA requirement. Frame Number Effective Range: 8FGU15-18 8FGU18-11533 and Higher 8FGU20-25 8FGU25-15748 and Higher 8FGU30-32 8FGU32-12676 and Higher 8FGCU15-S20 8FGCSU20-12589 and Higher 8FGCU20-25 8FGCU25-19092 and Higher 8FGCU30-32 8FGCU32-11833 and Higher