19-53 Electrical System Troubleshooting Error codes 15-1, 15-2 Disconnect the battery negative terminal, then inspect and repair disconnection of G36, G39, AG2 and starting motor relay and any water entry. Reconnect the connectors and the battery negative terminal, then repeat the operations c to f below several times and check whether an error occurs. c Turn the ignition key switch ON (engine stopped) d Operate the accelerator pedal ON/OFF (several times) e Start the engine with the accelerator fully depressed f Release the accelerator pedal and turn the ignition key switch OFF No error Connector contact defect Error NG Inspection 1:
NMR switch individual inspection NMR switch defect OK NG Inspection 2: Harness continuity and short circuit inspection Harness defect OK Inspection 3: Inspection of the status of the NMR switch which is detected by ASC controller ANL.: I/O ENGINE CTRL 1/3 NG ASC controller defect OK Refer to and carry out mechanical system inspection items such as link catching or switch position adjustment. Inspection 1: Carry out an NMR switch individual inspection. Ignition key switch OFF, disconnect G36, connect G39 Standard: (Switch side) G36 Section 19 Switch OFF Switch ON G36-1 ~ G36-2 No continuity Continuity