19-59 Electrical System Troubleshooting Error codes 16-1, 16-2 Disconnect the battery negative terminal, then inspect and repair disconnection and water entry of G39, G36 and G37. Reconnect the connectors and the battery negative terminal, then repeat the operations c to e below several times and check whether an error occurs. c Turn the ignition key switch ON (engine stopped) d Operate the accelerator pedal ON/OFF (several times) e Turn the ignition key switch OFF No error Connector contact defect Error NG Inspection 1: Idle switch individual inspection Idle switch defect OK NG Inspection 2: Carry out harness continuity and short circuit inspection Harness defect OK Inspection 3:
Inspection of the status of the idle switch which is detected by controller ANL.: I/O ENGINE CTRL 1/3 NG ASC controller defect OK Refer to and carry out mechanical system inspection items such as link catching or switch position adjustment. Inspection 1: Carry out idle switch individual inspection. Ignition key switch OFF, disconnect G36, connect G39 Standard: (Switch side) G36 Section 19 Switch OFF Switch ON G36-3 ~ G36-4 No continuity Continuity