19-86 19-86 Electrical System Troubleshooting z Error code 65-1 (Tilt control solenoid abnormality) Related portion A20 A10 4 (TSOL) 1 Tilt control solenoid 2 SAS/OPS controller 8 (E01) 9 (E02) Probable cause c Connector contact defect d Harness defect e Tilt control solenoid defect f SAS/OPS controller defect Error code 65-1 Connector contact defect Harness defect Solenoid defect SAS/OPS controller defect *: Make sure that no error is displayed when the material handling lever is operated to tilt forward. Inspection 1: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A10 and A20 Standard:
Section 19 Disconnect the battery negative terminal, after inspecting and correcting disconnection and water entry of A10 and A20, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON (engine stopped) and check whether or not there is an error.* No error Error Inspection 1: Harness continuity and short circuit inspection OK Inspection 2: Tilt control solenoid individual inspection OK A20-4 ~ A10-1 Continuity A10-2 ~ Frame Continuity A20-9 ~ Frame Continuity A20-8 ~ Frame Continuity A20-4 ~ Frame No continuity