Komatsu — CLEANING AND INSPECTION

OM4035.2 02/03 Maintenance - Section 4 Automatic Lube System Page 4- 23 PUMP REBUILD 14. Remove the pump plunger (20) from the plunger link rod (17). (A spanner wrench, which uses the holes in the the pump plunger, is required.) 15. Unscrew the plunger link rod (17) from the plunger tube (11) and slide off the cup seal (16) backup washer (15) and wrist pin anchor (14). Be certain to bleed steering accumulators to relieve hydraulic pressure and to relieve pump outlet grease pressure before removing any hoses or fit- tings. 16. Unscrew the plunger tube (11) from the outlet pin (9). 17.

To dismantle the crankrod assembly (1 through 8), remove flat head screws (1) and the inner and outer weights (2 & 3). Disassembly 18. Remove the small retaining rings (6) and press the crank eccentric (7) out of the ball bearing (8). Be sure to support the ball bearing on the inner race. 1. Remove the four socket head screws (33, Figure 3- 10) and separate the manifold (37) from the hydrau- lic motor (42). 2. Remove pipe plug (45) and drain the crankcase oil from pump housing (46). 3. Remove the six screws (29) and remove the hous- ing cover (30) and cover gasket (31). Cleaning and Inspection 1. Discard all seals and gaskets.

Repair kits are avail- able containing all the necessary seals and gaskets for reassembly. Refer to the appropriate truck parts book. 4. Remove retaining ring (57) and pull the shovel plug (56) from the housing tube (55). 5. Remove two socket head screws (44) and separate hydraulic motor (42) from the pump housing (46). 2. Clean and inspect the following parts. Replace if excessive wear is evident: 6. Remove two outlet pin nuts (50) from pump housing.

•Ball bearing (8) •Crank eccentric (7) •Crankrod (5) •Wrist pin bushings (13) •Plunger tube (11) •Pump plunger & upper check parts (20, 19 & 18) •Pump cylinder (24) •Check seat housing/lower check ball (28, 26) •Upper bronze bushing (51) •Housing tube (55) •Shovel plug (56) •Reciprocating tube (21) 7. Remove the pump subassembly (1 through 28) from the pump housing. Pushing the subassembly up with a .75 in. (19 mm) diameter wooden or plastic rod against the check seat housing (28) is helpful. 8. Remove the housing tube (55) from the pump housing by inserting a .75 in. (19 mm) diameter rod through the inlet holes at the bottom of the housing tube and unscrewing it. 9.

Remove the bronze bearing (51), O-ring (52), back- up washer (53), and O-ring (54) from the housing tube. 10. Remove the crankrod assembly (1 through 8) from the pump by unscrewing the button head screws (12) and then pulling out the wrist pin bushings (13). 11. Remove the check seat housing (28) from the recip- rocating tube (21). Note: There is a 3/8 in. allen head socket in the throat of the check seat housing to facilitate removal. 12. Unscrew the wrist pin anchor (14) from the recipro- cating tube (21) and pull the plunger assembly (9 through 20) from the tube. 13. Using a .50 in.

(13 mm) diameter wooden or plastic rod, push the cup seal (22) and the pump cylinder (24) from the reciprocating tube.