Komatsu — DUMPING

Operation - Section 3 OM3035.1 02/03 Page 3-8 Operating Instructions DUMPING 1. Pull into dump area with extreme caution. Make sure area is clear of persons and obstructions, including over- head utility lines. Obey signals directed by the spotter, if present. Avoid unstable areas. Stay a safe distance from edge of dump area. Position truck on a solid, level surface before dumping. As body raises, the truck Center of Gravity (CG) will move. Truck must be The dumping of very large rocks (10% of payload, or greater) or sticky mate- rial (loads that do not flow freely from the body) may allow the material to move too fast and cause the body to move RAPIDLY and SUDDENLY.

This sudden movement may jolt the truck violently and cause possible injury to If dumping very large rocks or sticky mate- rial as described in WARNING above, slowly accelerate engine RPM to raise body. When the material starts to move, release hoist lever to "HOLD" position. If material does not continue moving and clear body, repeat this procedure until material has cleared body. 6. Reduce engine RPM as last stage of hoist cylinder begins to extend and let engine go to low idle as last stage reaches half-extension. 7. Release hoist lever as last stage of hoist cylinder reaches full extension. To Lower Body: (When dumping over a berm or into a crusher): 8.

Move hoist lever forward to "down" position and release. Releasing the lever places hoist control valve in the "float" position allowing the body to return to frame. NOTE: If dumped material builds up at the rear of the body and the body cannot be lowered, perform steps "a" & "b" below: a. Move hoist lever back to the "hoist" position to fully raise the dump body. Then release the hoist lever so it returns to the "hold" position. NOTE: DO NOT drive forward if the tail of body will not clear the crusher wall in the fully raised position. b. Shift Selector Switch to "Forward", release Brake Lock, depress Override button and drive forward to clear the material.

Stop, shift Selector Switch to "Neutral", apply Brake Lock and lower body again. As body raises, th on level surface to 2. Carefully maneuver truck into dump position. Wh ated brake pedal to stop and hold truck; DO N unmodulated and applies REAR SERVICE BRAK 3. When truck is stopped and in dump position, ap "Neutral" position. To Raise dump body: The dumping of very rial (loads that do n move too fast and c sudden movement the operator, and/or damage to the hoist cylinder dump this kind of material, refer to the CAUTION in 4. Pull the lever to the rear to actuate hoist circuit.

( body in "hold" at that position.) Th ria mo su the operator, and/or damage to t dump this kind of material, refer t 4. Pull the lever to the rear to act body in "hold" at that position.) 5. Raise engine RPM to accelera te hoist speed. Ref