Komatsu — HYDRAULIC TANK SERVICE

OM4035.1 01/04 Maintenance - Section 4 Lubrication and Service Page 4-1 LUBRICATION AND SERVICE Recommended Preventive Maintenance will contribute to the long life and dependability of the truck and its components. The use of proper lubricants and the per- formance of checks and adjustments at recommended intervals is most important. HYDRAULIC TANK SERVICE There are two sight gauges on the side of the hydraulic tank. With engine stopped, keyswitch "off", hydraulic system bled down and body down, oil should be visible in the top sight gauge. If hydraulic oil is not visible in the top sight gauge, follow "Adding Oil" instructions below.

Lubrication requirements are referenced to the lube key found in the Truck Lubrication Specifications Chart (page 4-2). For detailed service requirements for spe- cific components, refer to the Shop Manual Section for that component (i.e. Section “H” for Suspensions, Sec- tion "L" for Hydraulic System, etc.). Adding Oil Keep the system open to the atmosphere only as long as absolutely necessary to lessen chances of system contamination. Refer to manufacturer's service manual when servicing any components of the General Electric System. Refer to engine manufacturer's service manual when servicing the engine or any of its components. Service the tank with clean Type C-4 hydraulic oil only.

All oil being put into the hydraulic tank should be fil- tered through 3 micron filters. 5. With engine stopped, keyswitch "off", hydraulic system bled down and body down, check to see that hydraulic oil is visible in the top or lower sight gauge. 6. If hydraulic oil is not visible in the top sight gauge, remove the tank fill cap and add clean, filtered C- 4 hydraulic oil (Lubrication Chart, Lube Key "D") until oil is visible in the top sight gauge. 7. Replace fill cap. 8. Start engine. Raise and lower the dump body three times. 9.

Repeat steps 1 through 4 until oil is maintained in the top sight gauge with engine stopped, body down, and hydraulic system bled down The service intervals presented here are in hours of operation. These intervals are recommended in lieu of an oil analysis program which may determine different intervals. However, if truck is being operated under extreme conditions, some or all, of the intervals may need to be shortened and the service performed more frequently. Many Komatsu trucks are equipped with an Automatic Lubrication System option. The initial setup for this sys- tem provides for nominal amounts of lubricant to be delivered to each serviced point.

The lubrication injec- tors can be adjusted to vary the amount of lubricant delivered. In addition, the timer for lubrication intervals is normally adjustable. Consult the "Options and Accessories", Section "M", of the truck service manual for adjustments to these devices. 730E SERVICE CAPACITIES Crankcase: (including lube oil filters). Komatsu SSA16V159 Engine Liters U.S. Gal- lons 214 56.6 Cooling System: Komatsu SSA16V159 Engine 409 108 Hydraulic System: Refer to "Hydraulic Tank Ser- vice". 731 193 Wheel Motor Gear Box (each side) 39.7 10.5 Fuel Tank (Diesel Fuel Only) 3217 850