. OPERATION MACHINE OPERATIONS AND CONTROLS Checks Before Starting Check Coolant Level, Add Coolant WARNING on of If 3 - 72 Always check the items in thi s section before starting the engi ne each Do not open the radiator cap u nless necessary. When checking the coolant, a lways wait for the engin e to cool down and check the sub tank. Immediately after the engine i s stopped, the coolant is at a high tem perature and the radiator is und er high internal pressure. If the cap is removed to check the coolant level in this condition, t here is a hazard of burns. Wait for the temperature to go down, then turn the cap slowl y to release the pressure and remove it carefully. 1.
Open the rear door at the l eft of the machine and check that cooling water level is bet radiator sub tank (1) (sho ween the FULL and LOW marks wn in the diagram on the right). If the water level is low, ad d water through the water filler of s tank (1) to the FULL level . ten the cap securely. mpty, there is probably leakage repair any problem immediately 2. 3. After adding coolant, tigh If the sub-tank (1) is e coolant. After inspecting, there is no problem, chec k the coolant level in the radiato the coolant level is low, a dd coolant to the radiator, then fill sub-tank (1). Drain Water And Sediment fro m Fuel Tank right of the machine. 1. 2. 3. 4. 5. 1.
Open the rear door at the Set a container under the it is drained. Turn drain valve (1) to the sediment and water accu drain valve (1) to catch the fuel wh OPEN (O) position and drain all mulated at the bottom together w the fuel. When clean fuel comes o (S) position. Close the door. ut, turn drain valve (1) to the CLO 5.