. OPERATION TRANSPORTATION LIFTING MACHINE WARNING 3 - 139 The ope rator carrying out the lift ing operation using a cran e must be a prope rly qualified crane ope Never r aise the machine with an Always make sure that the wire r ope is of ample strength f or the weight of thi When li fting, keep the machine h When c arrying out lifting operatio ns, set the lock lever to the LOCK position to prevent the machine fr om moving unexpectedly. Never e nter the area under or aro und a raised machine. Never try t o lift the machine in any p osture other than the pos ture given in the pr ocedure below or usin g lifting equipment other than in the procedure below. may lose its balance.
There is a hazard that the machine NOTICE od of lifting applies to the standard specification machine. d of lifting differs according to the attachments and options installed. This meth od of lifting applies to the standard specification m The metho d of lifting differs accord ing to the attachments and options installed. For details of the procedure for mac hines that are not the sta ndard specification , please consult your For weigh t, see "SPECIFICATI ONS (PAGE 5-2)". When lifti ng the machine, carry out the operation on fla t ground as follo 1. Start the engine, then the swing the upper structure so that the work equipment will be on the side of sprocket (1). 2.
Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 1. Start the engine, then the sw ing the upper structure so that the equipment will be on t he side of sprocket (1). then lower 2. Exten d the bucket cylinder and arm cylinder fully, ork equipment to the g round as shown in the diagram on 3. Set th e lock lever securely t o the LOCK position (L 4. Stop the engine, check that there is nothing around the operator's c ompartment, then g Close the cab door and fron t glass securely.