. OPERATION TROUBLES AND ACTIONS TROUBLES AND ACTIONS starting the engine. pump it in REMARK or 3 - 147 RUNNING OUT OF F When starting the engine again after running out of fu el, fill with f uel, then bleed the air from the fuel system before Procedure for Bleeding A ir t the right of the machine. 1. Open the rear door a 2. Loosen the knob of f and out until the mov 1. Open the rear door a eed pump (1), pull it out, th ement becomes heavy. It is not necessary to rem ove the plug at the top of the fuel pre-filt and fuel main filter. 3. Push in the knob of f eed pump (1) and tighten it. 4.
Turn the key in the s tarting switch to the START position an d start not crank the starting motor c ontinuousl y for more than 20 seconds . If the engine does no 2 minutes, then try again. Perform thi s operation a maximum of PHENOMENA THAT ARE NOT FAILURES Note that the following phenomena are not failures: Note that the following p When the arm control l ever is operated to the IN po sition and th work equipment is low ered under no load from a h igh positio the arm speed will dro p momentarily when the arm is more ition.
less at the vertical pos When the bucket cont rol lever is operated to the C URL positio and the work equipme position, the bucket nt is lowered under no load from a hig speed will drop momentari ly when th ition. bucket teeth are more or less at the horizontal pos The bucket or arm w digging operations. ill fluctuate by itself during heavy-du When starting or stop ping the swing, noise will be emitted fro m the brake valve. When going down a s teep slope at low speed, a n oise will be emitted from the travel m