Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 28 4. Remove the co ver (2), then set the container under drain valve (3) to catch the coolant mixture. Open drain val ve (3) at the bottom of the radi ator and drain the coolant. After draining t he coolant, close drain valve ( 3), and fill with city water. When th idling to raise t e radiator is full, start the engi he temperature to at least 90 for approx. 10 minutes. e and open drain valve (3) to continue to run Stop the engin 7. After draining t he water, clean the radiator w For the cleanin g method, follow the instructi 8. Close drain val 9. Install cover (2 10.

Add coolant mi xed with antifreeze until it ove rflows from the water filler. Decide the pro portions of antifreeze and wat er according to the table for the mixing rat e of water and antifreeze. 11. Run the engine at low idling for 5 minutes to r emove the air fro m the water, then run at high idling for 5 minutes. (Leave radiator cap (1) removed when doing 12. Drain the cool ant from sub-tank (4), clean sub-tank, then FULL and LOW If the sub-ta replace it wit sub-tank, then FULL and LOW add water until the coolant level is between the marks. If the sub-ta nk is extremely dirty and it is difficult to clean, h a new part. 13. Stop the engine, wait for approx.

3 minutes, add city water up to near the mouth of the filler port, then tighten radiator cap (1). Stop the engin to near the mou e, wait for approx. 3 minutes, th of the filler port, then tighte add city water up n radiator cap (1).