SAFE OPERATION - 5 2. Keep the PTO shaft cover in place at all times. Replace the PTO shaft cap when the shaft is not in use. 6. SERVICING THE TRACTOR Before servicing the tractor, park it on a firm, flat and level surface, set the parking brake, lower all implements to the ground, place the gear shift lever in neutral, stop the engine and remove the key. 1. Allow the tractor time to cool off before working on or near the engine, muffler, radiator, etc. 2. Do not remove radiator cap while coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely.
If the tractor has a coolant recovery tank, add coolant or water to the tank, not the radiator. (See "Checking Coolant Level" in "DAILY CHECK" in "PERIODIC SERVICE" section.) 3. Always stop the engine before refueling. Avoid spills and overfilling. 4. Do not smoke when working around battery or when refueling. Keep all sparks and flames away from battery and fuel tank. The battery presents an explosive hazard, because it gives off hydrogen and oxygen especially when recharging. 5. Before "jump starting" a dead battery, read and follow all of the instructions. (See "JUMP STARTING" in "OPERATING THE ENGINE" section.) 6. Keep first aid kit and fire extinguisher handy at all times. 7.
Disconnect the battery's ground cable before working on or near electric components. 8. To avoid the possibility of battery explosion, do not use or charge the refillable type battery if the fluid level is below the LOWER (lower limit level) mark. Check the fluid level regularly and add distilled water as required so that the fluid level is between the UPPER and LOWER levels. 9. To avoid sparks from an accidental short circuit, always disconnect the battery's ground cable (-) first and reconnect it last. (1) PTO Shaft cover (2) PTO Shaft cap (A) "NORMAL POSITION" (B) "RAISED POSITION" 3.
Before installing or using PTO driven equipment, read the manufacturer's manual and review the safety labels attached to the equipment. 4. When operating stationary PTO driven equipment, always apply the tractor parking brake and place chocks behind and in front of the rear wheels. Stay clear of all rotating parts. Never step over rotating parts. 5. USING 3-POINT HITCH 1. Use the 3-point hitch only with equipment designed for 3-point hitch usage. 2. When using a 3-point hitch mounted implement, be sure to install the proper counterbalance weight on the front of the tractor. 3. To avoid injury from separation: Do not extend lift rod beyond the groove on the threaded rod.
(1) Groove (1) Battery 10.Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper equipment.