hyundai — 3. ELECTRICAL SYSTEM

4. WHEN COOLANT OVERHEAT WARNING LAMP LIGHTS UP(Engine is started) 余 Before disconnecting the connector, always turn the starting switch OFF. 余 Before carrying out below procedure, check all the related connectors are properly inserted. 余 After checking, insert the disconnected connectors again immediately unless otherwise specified. Start switch : OFF MCU CN-51 CN-2 210S6ES53 6-27 YES Resistance ( YES between CD-8 (1,2) is in range of 120~150凂? NO Disconnect CD-8 Does display go off when disconnect CD-8? YES Starting switch : ON Engine : Start Resistance between CN-51 NO (31,33) is 0~1凂?

NO Disconnect CN-51 Cause Remedy Coolant overheat 110佘C佳2佘C) Defective temp sensor Short circuit in wiring harness Defective MCU Check engine cooling system Replace Repair or replace (After clean) Replace GND (SENSOR) 31 WATER TEMP SENSOR 33 11 12 WATER TEMPERATURE 1 oC 2 CD-8 1 2 oC