7. WHEN HYDRAULIC OIL TEMPERATURE WARNING LAMP LIGHTS UP (Engine is started) 余 Before disconnecting the connector, always turn the starting switch OFF. 余 Before carrying out below procedure, check all the related connectors are properly inserted. 余 After checking, insert the disconnected connectors again immediately unless otherwise specified. MCU HYDRAULIC OIL TEMPERATURE SENDER HYD TEMP SENSOR 34 GND (SENSOR) 31 CD-1 CN-51 210S6ES57 6-30 YES Resistance YES between CD-1 (1,2) is in range of 130~150凂? Does display go Starting switch : ON NO off when Disconnect CD-1 s disconnect YES CD-1? Starting switch : ON Resistance Engine : Start between CN-51 NO (31,34) is 0~1凂? Starting switch :
OFF NO Disconnect CN-51 Cause Remedy High temperature Defective torque ensor Short circuit Defective MCU Check hydraulic oil temperature (100佘C佳2佘C) , Replace Replace Check and repair Replace 2 1 C