hyundai — 9. BOOM, ARM AND BUCKET CYLINDER

Note that the plated surface of rod assembly (2) is to be lifted. For this reason, do not use a wire sling and others that may damage it, but use a strong cloth belt or a rope. 刲 Place the removed rod assembly on a wooden V-block that is set level. Cover a V-block with soft rag. Piston assy 侍 Wooden block 21078DA33 (2) 刮 刯 侍 Remove piston and cylinder head Remove set screw (21). Remove lock nut (20). Since piston (14) and lock nut (20) are tightened to a high torque, use a hydraulic and power wrench that utilizers a hydraulic cylinder, to remove the piston (14) and lock nut (20). Remove piston assembly (14), back up ring (19), and O-ring (18). Remove cushion ring (13).

19 18 13 14 20 21 到 2907A8CY02 刱 Plastic hammer 刲 Remove the cylinder head assembly from rod assembly (2). If it is too heavy to move, move it by striking the flanged part of cylinder head with a plastic hammer. Pull it straight with cylinder head assembly lifted with a crane. Exercise care so as not to damage the lip of rod bushing (4) and packing (5,6,7,8,9,10) by the threads of rod assembly (2). Lift with a crane 侍 Pull straight 侍 21078DA35 8-136 8-136