FUSIBLE LINK OPERATION If the starting motor does not turn when the ignition switch is turned to the ON position, there is probably a disconnection in fusible link (1) or (2). Open the battery box cover on the right side of the chassis, then check and replace the fusible link. (1): Fusible link for 24 V power supply (2): Fusible link for starting motor Fusible link (2) is taped to the nearby wiring harness. When carrying out inspection or replacement, check the wiring harness number.
Remark A fusible link refers to the large-sized fuse wiring installed in the high current flow portion of the circuit to protect electrical components and wiring from burning, in the same way as an ordinary fuse. CONTROLLER The controllers are installed in the locations listed below, do not tamper with or allow these controllers to get wet. If a problem should occur, contact your Komatsu distributor. Engine controller Open the front engine hood. It is under the fuel pre-filter. Pump controller This controller is on the right side at the rear of the operators seat. PC400LC-7E0 2-69