OPERATION CHECKS BEFORE STARTING Always check the items in this section before starting the engine. CHECK COOLANT LEVEL, ADD COOLANT Do not open the radiator cap unless necessary. When checking the coolant, wait for the engine to cool down and check the sub tank. Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under high internal pressure. If the cap is removed to drain the coolant in this condition, there is a danger of burns. Wait for the temperature to go down, then turn the cap slowly to release the pressure before removing it. 1.
Open the door at the rear of the machine, and check if the cooling coolant in sub-tank (1) (shown in the diagram on the right) is between the FULL and LOW marks. If the coolant level is low, add coolant to the FULL level through the filler port of sub-tank (1). 2. After adding coolant, tighten the caps securely. 3. If the sub tank is empty, there is probably leakage of coolant. After inspecting, repair any abnormality immediately. If there is no abnormality, check the coolant level in the radiator. If the coolant level is low, add coolant to the radiator, then fill the reserve tank (1). DRAIN WATER AND SEDIMENT FROM FUEL TANK 1. Set a container under the drain hose to catch the drained fuel.
2. Open drain valve (1) to the OPEN (O) position and drain the water and sediment accumulated at the bottom together with the fuel. 3. When no more water and sediment comes out with the fuel, close drain valve (1) to the CLOSE (S) position. PC400LC-7E0 2-71