Komatsu — WARMING UP HYDRAULIC EQUIPMENT

13. Check to be sure the hydraulic oil temperature monitor and engine coolant temperature monitor are displaying green, then check to be sure all the gauges and caution monitors on the machine moni- tor our in the following status. OPERATION Radiator coolant level monitor (8): OFF Charge level monitor (9): OFF Engine oil pressure monitor (10): ON Engine oil level monitor (11): OFF Air cleaner clogging monitor (12): OFF Engine pre-heating monitor (14): OFF Engine coolant temperature gauge (15): Indicator in green range Engine coolant temperature monitor (1): Green display Hydraulic oil temperature gauge (16): Indicator in green range Hydraulic oil temperature monitor (16):

Green display Fuel gauge (17): Indicator in green range Fuel level monitor (18): Green display 14. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. In cold temperatures (ambient temperature below 0 o C [32°F]), even when the hydraulic oil temperature monitor displays green, carry out additional Step 15 to warm up all the hydraulic equipment. 15. Turn fuel control dial (4) to the full speed (MAX) position, repeat Steps 6 to 9 for 3 to 5 minutes, then check again that the hydraulic oil temperature monitor is displaying green.

If it is not displaying green, repeat Steps 6 to 9 for 3 to 5 minutes until hydraulic oil temperature monitor (7) displays green. PC400LC-7E0 2-89