OPERATION ESCAPING FROM MUD Always operate carefully to avoid getting stuck in mud. If the machine does get stuck in mud, do as follows to get the machine out. Place the machine push-up switch in the high-pressure set position (b). This will increase the push power of the boom. ONE SIDE OF TRACK STUCK Remark When using the boom or arm to raise the machine, always have the bottom of the bucket in contact with the ground. (Never push with the teeth). The angle between the boom and arm should be 90є to 110є. The same applies when using the inverting bucket. When only one side is stuck in mud, use the bucket to raise the track, then lay boards or logs and drive the machine out.
If necessary, also put a board under the bucket. BOTH SIDES OF TRACKS STUCK If the tracks on both sides are stuck in mud and the machine slips and cannot move, use the procedure given above to lay logs or timber. Dig the bucket into the ground at the front, operate the arm in the same way as when digging, and set the travel lever to FORWARD to pull the machine out. PC400LC-7E0 2-103