Komatsu — MACHINE INSPECTION AFTER DAILY WORK

OPERATION MACHINE INSPECTION AFTER DAILY WORK BEFORE STOPPING ENGINE Check the engine coolant temperature, engine oil pressure, and fuel level on the machine monitor. Remark After stopping the engine, if the ignition switch is turned within approx. 10 seconds to the ON or START position to start the engine again, the monitor display is not reset, and the screen before the ignition switch was turned OFF is displayed. AFTER STOPPING ENGINE Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for any leakage of oil or coolant. If any problems are found, repair them. FILL THE FUEL TANK. Check the engine compartment for paper and debris.

Clean out any paper and debris to avoid a fire hazard. Remove any mud affixed to the undercarriage. Remark Always remove the ignition key from the ignition switch, lock all lockable areas, lower the work equipment to the ground and neutralize controls. 2-106 PC400LC-7E0