OPERATION Remark Carry out installation in the reverse order to removal. When installing the bucket: For arm pin part (A), fit an O- ring at the position on the bucket shown in the diagram on the right. After inserting the pin, fit it into the proper groove. For link pin part (B), install the bucket with the O-ring fitted in the proper groove. 4. Install the stopper bolts and nuts for each pin, then grease the pin. Remark Lubricate with grease thoroughly until the grease comes out from the end face. When replacing the bucket, replace the dust seal if it has been damaged.
If a damaged seal is used without being replaced, sand and dirt may enter the pin portion and cause abnormal wear of the pin. If the bucket is lowered strongly to the ground, the resistance will be increased and it will be difficult to remove the pins. Remark After removing the pins, make sure that mud or sand does not get on them. Dust seals are fitted at both ends of the bushings, be careful not to damage them. 2. Remove the double nut on the stopper bolt for arm pin (A) and link pin (B), remove the bolt, pull out arm pin (A) and link pin (B), and then remove the bucket. 3. After removing the bucket, reverse it. 4.
Align arm (5) with replacement bucket hole (1), then align link (6) with hole (2), coat pins (A) and (B) with grease, and install. 2-118 PC400LC-7E0 BUCKET INVERSION The rock bucket (PC400: If equipped) interferes with the arm, so it CANNOT be reversed to carry out excavation to the front. 1. Place the bucket in contact with a flat surface. Remark When removing the pins, place the bucket so that it is in