OPERATION ENGINE PROBLEMS (): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs.
PC400LC-7E0 2-145 Problem Main causes Remedy Engine oil pressure monitor lights up ● Engine oil pan oil level is low (sucking in air) ● Clogged oil filter cartridge ● Defective tightening of oil pipe, pipe joint, oil leakage from dam- aged point ● Defective engine oil pressure sensor ● Defective monitor ● Add oil to specified level, see “WARN- ING ALERTS” on page 2-11 ● Replace cartridge, see “EVERY 500 HOURS MAINTENANCE” on page 3- 51 ● (Check, repair) ● (Replace sensor) ● (Replace) Steam spurts out from top of radiator (pressure valve) ● Cooling water level low, leakage of coolant ● Loose fan belt ● Dirt or scale accumulated in cooling system ● Check, add water, repair, see “WARN- ING ALERTS” on page 2-11 ● Check fan belt tension, adjust, replace ● Change coolant, flush inside of cooling system, see “WHEN REQUIRED” on page 3-20 Radiator coolant level monitor lights up ● Clogged radiator fins or dam- aged fins ● Defective thermostat ● Loose radiator filler cap (high-altitude operations) ● Defective water level sensor ● Defective monitor ● Clean or repair, see “EVERY 500 HOURS MAINTENANCE” on page 3- 51 ● (Replace thermostat) ● Tighten cap or replace packing ● (Replace sensor) ● (Replace sensor) Engine does not start when starting motor is turned ● Lack of fuel ● Air in fuel system ● Defective fuel injection pump or defective nozzle ● Starting motor cranks engine sluggishly ● Preheating monitor does not light up ● Poor compression ● Defective valve clearance ● Add fuel, see “STARTING THE ENGINE” on page 2-82 ● Repair place where air is sucked in, see “EVERY 500 HOURS MAINTE- NANCE” on page 3-51 (Replace pump or nozzle) ● See “ELECTRICAL SYSTEM PROB- LEMS” on page 2-143 ● See “ELECTRICAL SYSTEM PROB- LEMS” on page 2-143 ● (Adjust valve clearance) Exhaust gas is white or blue ● Too much oil in oil pan ● Improper fuel ● Set oil to specified level, see “PRE- OPERATIONAL CHECKS” on page 2-70 ● Change to specified fuel