MAINTENANCE MAINTENANCE INFORMATION Do not perform any inspection and/or maintenance operation that is not found in this manual. SERVICE METER READING Check the service meter reading every day to see if the time has come for any necessary maintenance. KOMATSU GENUINE REPLACEMENT PARTS Use Komatsu genuine parts specified in the Parts Book as replacement parts. KOMATSU GENUINE LUBRICANTS Use Komatsu genuine oils and grease. Choose oils and grease with proper viscosities specified for ambient temperature. WINDSHIELD WASHER FLUID Use automobile windshield washer fluid, and be sure not to let any dirt get into it. FRESH AND CLEAN LUBRICANTS Use clean oil and grease.
Also, keep the containers of the oil and grease clean. Keep foreign materials away from oil and grease. CHECK DRAINED OIL AND USED FILTER After oil is changed or filters are replaced, check the old oil and filters for metal particles and foreign materials. If large quan- tities of metal particles or foreign materials are found, report to the person in charge, and correct situation. FUEL STRAINER If your machine is equipped with a fuel strainer, do not remove it while fueling. WELDING INSTRUCTIONS Turn off the engine ignition switch. Do not apply more than 200V continuously. Connect grounding cable within 1 m (3.3 ft) from the area to be welded.
If grounding cable is connected near instruments, connectors, etc., the instruments may malfunction or fail. Avoid seals or bearings from being between the area to be welded and the position of grounding point. Do not use the area around the work equipment pins or the hydraulic cylinders as the grounding point. DO NOT DROP THINGS INSIDE MACHINE When opening inspection windows or the oil filler port of the tank, be careful not to drop nuts, bolts, or tools inside the machine. If such things are dropped inside the machine, it will cause damage, machine malfunction, and will lead to failure. If you drop anything inside the machine, remove it immediately.
Do not put unnecessary things in your pockets. Carry only things which are necessary for inspection. SELECTING FUEL AND LUBRICANTS TO MATCH AMBIENT TEMPERATURE It is necessary to use fuel and lubricants that match the ambient temperature. For details, see “RECOMMENDED FUEL, COOLANT, AND LUBRICANT” on page 3-10 3-2 PC400LC-7E0