Komatsu — REPLACE BUCKET TEETH (VERTICAL PIN TYPE)

MAINTENANCE If the lock pins and rubber pin locks with the following defects are used. the teeth may come off the bucket. Replace them with new ones. The lock pin is too short. Dimension (B) is 1/3 or more of dimension (A) when locking pin (2) is aligned with bottom face (C). The rubber (6) of the rubber pin lock is torn, and the steel balls may come out. The steel balls (7) are buried when they are pressed by hand. 5. Clean the adapter surface (4) and remove the soil with a knife. 6. Use your hand or a hammer to push the rubber in lock (3) into the adapter hole. When doing this, be careful that the rubber pin lock does not fly off of the adapter surface. 7.

Clean the inside of teeth, then install it to adapter (4). If there is mud stuck to it or if there are protrusions, the teeth will not enter the adapter properly, and there will not be proper contact at the mating portion. 3-32 PC400LC-7E0