MAINTENANCE 4. Clean the mounting face. Fit a new tooth (2) in the adapter, push in pin (1) partially by hand, then lock it with a hammer to install the tooth to the bucket. REPLACE BUCKET SIDE CUTTER, SHROUD It is dangerous if the work equipment is mistakenly moved when replacing the bucket side cutters and shroud. Set the work equipment in a stable condition, stop the engine, then set lock lever securely to the LOCK position (L). As the locking pin is knocked out with force, there is danger that the pin may fly out. Check that there is no one near the machine. Broken pieces may fly during the replacement operation, so always wear safety glasses, gloves, or other protective equipment.
SIDE CUTTERS Loosen mounting bolts (2), then remove side cutter (1). Replace the side cutter, bolts, and nuts with new parts. Torque of bolt: . . . . . . . . 1370 - 1670 Nm (1010 - 1232 ft/lbs) Shroud Place a bar on the head of pin (1), strike the bar with a hammer to knock out the pin, then remove tooth (2). Remark If it cannot be removed, contact your Komatsu distributor. PC400LC-7E0 3-35