Komatsu — CHECK OIL LEVEL IN MACHINERY CASE, ADD OIL

EVERY 250 HOURS MAINTENANCE MAINTENANCE LUBRICATE SWING CIRCLE 1. Lower the work equipment to the ground. 2. Using a grease gun, pump in grease through the grease fittings shown by arrows. (2 places) 3. After greasing, wipe off any old grease that was pushed out. CHECK OIL LEVEL IN MACHINERY CASE, ADD OIL The parts and oil are hot after the engine is stopped, and may cause serious burns. Wait for the temperature to cool before starting the operation. 1. Remove dipstick (G) and wipe the oil from the dipstick with a cloth. 2. Fully insert dipstick (G) into the filler pipe. 3. When dipstick (G) is pulled out, if oil level is between the (H) and (L) marks of the gauge, oil level is proper. 4.

After replacing the filter cartridge, add engine oil through oil filler port so that the oil level is between the (H) and (L) marks on dipstick (G). 5. If the oil level is above the (H) mark on dipstick (G), loosen drain valve (P) and drain the excess oil. When draining the oil, first pull hose (2) out from inspection hole (B), then turn the drain valve to the OPEN position. 6. After checking oil level or adding oil, insert the dipstick into the hole and install air bleeding plug (1). PC400LC-7E0 3-45