2. Open the front engine hood. 3. Set the container to catch the fuel under the filter cartridge (2). 4. Using a filter wrench, turn transparent cap (3) to the left to remove it. (This cap is used again.) 5. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. MAINTENANCE 6. Remove seal (4) from transparent cap (3), then clean the cap. If transparent cap (3) is damaged, replace it with a new part. 7. Coat new seal (4) with clean fuel or oil, then install it to transparent cap (3). 8. Install transparent cap (3) to new filter cartridge (2). Torque for transparent cap: . . . . . . . . . . . . . 10.0 Nm (7.2 lbft) 9.
Check that the drain plug at the bottom of transparent cap (3) is tightened securely. Torque: . . . . . . . . . . . . . . . . . . . . 0.2 - 0.45 Nm (0.1 - 0.3 lbft) 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. Remark When adding fuel, do not remove cap (B). Always add fuel from the 8 small holes (A) on the dirty side. After adding fuel, remove cap (B) and install the fuel filter. Always fill with clean fuel. Be careful not to let any dirt or dust get into the fuel. In particular, center portion is the clean side, so do not remove cap (B) when adding fuel.
Be careful not to let dirt or dust get into center portion on the clean side. 11. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten the correct amount. When tightening with a filter wrench, be extremely careful not to dent or damage the filter. PC400LC-7E0 3-53