Komatsu — REPLACE FUEL MAIN FILTER CARTRIDGE

5. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. MAINTENANCE Remark Do not fill the new filter cartridge with fuel. Remove cap (B) and install the filter cartridge. 6. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten the correct amount. 7.

Turn the valve (1) at the bottom of the fuel tank to the OPEN position (O). 8. After completing the replacement of filter cartridge (2), bleed the air. Bleed the air as follows: 9. Add fuel to the fuel tank until full (to FULL mark on the fuel gauge). 10. Loosen air bleed plug (C) at the fuel main filter head (3). 11. Loosen wing nut (6) holding lever (5) of priming pump (4). 12. Push in lever (5) repeatedly. Check that bubbles come out with the fuel from air bleed plug (C). 13. Tighten air bleed plug (C). Torque: . . . . . . . . . . . . . . . . . . . . 4.9 to 6.9 Nm (3.6 to 5.1 lbft) 14. Tighten wing nut (6) securely to lock lever (5) in position. Target torque:. . . . . . . . . . . . . . .

. . . . . . . . . 11.8 Nm (8.7 lbft) 15. After replacing the filter cartridge, start the engine and run it at low idling for 10 minutes. Check for leakage of oil from the filter seal surface. If any oil is leaking, check the tightening of the filter cartridge. If there is still oil leakage, repeat Steps 1 - 4 to remove the filter cartridge, and if any damage or embedded foreign material in the packing surface is found, replace it with a new cartridge and repeat Steps 5 - 15 to install it. PC400LC-7E0 3-61