Komatsu — CHANGE OIL IN SWING MACHINERY CASE

MAINTENANCE CHANGE OIL IN SWING MACHINERY CASE Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. Refill capacity: . . . . . . . . . . . . . . . . . . 13.4 liters (3.54 US gal) 1. Remove cover (A) of the inspection hole. (Only demolition specification machine) 2. Set a container under drain valve (P) under the machine body to catch the oil. 3. Loosen drain valve (P) under the body, drain the oil, then tighten the drain valve again. When draining the oil, first pull hose (2) out from inspection hole (B), then turn the drain valve to the OPEN position. 4.

Remove dipstick (G) and air bleed plug (1). 5. Add the replacement amount of oil through the insertion guide for dipstick (G). 6. Check the oil level. See “CHECK OIL LEVEL IN MACHINERY CASE, ADD OIL” on page 3-45. 7. Install air bleed plug (1). PC400LC-7E0 3-63