MAINTENANCE REPLACE CORROSION RESISTOR CARTRIDGE (IF EQUIPPED) The oil is at high temperature after the engine has been operated, so never replace the cartridge immediately after finishing operations. Wait for the oil to cool down before replacing cartridge. 1. Open the front engine hood. 2. Screw in 2 valves (1) at the top of the corrosion resistor. 3. Using a filter wrench, turn cartridge (2) to the left to remove it. 4. Install a new filter cartridge after coating oil on its sealing face. In the installation, turn the cartridge by two-thirds of one turn after the packing surface comes to contact with the sealing face of the cartridge stand.
A genuine Komatsu filter cartridge is recommended for use. 5. Open valves (1) (2 places). 6. Run the engine and check that there is no leakage of water from the seal surface. CHECK FAN BELT AND ALTERNATOR DRIVE BELT TENSION, REPLACE Special tools are required for inspection and replacement of the fan belt. Contact your Komatsu distributors for inspection and replacement. Remark An installed auto fan belt tension adjuster, “Auto Tensional Fan Belt”, dispenses with the belt deflection adjustment. PC400LC-7E0 3-65