SAFETY WORK SITE HAZZARDS Before proceeding with any excavating operations it is important to be aware of the hazards involved with this operation. Below is a list outlining what to do to avoid some of these hazards. Before starting any excavating operations, contact all utility departments in your area and have them identify and mark any underground system locations, (gas lines, water lines, electrical lines, sewer lines, etc.). Check your work area for any unusual ground conditions. Make sure your work area is as level as possible and you will be able to maneuver your work equipment or machine easily.
If you will be working near a high traffic area, (pedestrians or cars) have a dedicated worker available to direct traffic or install safety fencing around your work site. Always be aware of all your work site dangers or distractions. Always be aware of the worksite where open burning is allowed. Airborne sparks or glowing embers may cause fire on the machine. Operations such as logging, mulching, land clearing or landfill operations may cause trash and debris to accumulate on the machine. Remove debris or trash on a daily or more frequent basis as necessary to prevent fire. Always clean trash from the exhaust system compartments.
The hot exhaust compartments may cause fire from contact with flammable material. Remove any leaves, wood chips, paper, wood dust or anything that could catch fire accumulated around the engine. AVOIDING DANGEROUS SITUATIONS Always be aware of the swing circle area of the machine, especially in tight operating conditions. Never allow other personnel near your machine while in operation the possibility of hitting or pinning other personnel between the machine and another objects becomes greater the closer they are to your machine. Always maintain a clear and visible swing circle area during machine operations at all times. Never work under overhangs or excavated bank areas.
These could collapse and damage the machine or injure the operator. 1-22 PC400LC-7E0