Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER 3 - 129 When adjusting, it is dangerous if the wor k equipment is mo ved by mistake. Set the work equipmen t in a safe condition, then stop the engine and loc k the work equipment securely with the work equipment lock le NOTICE s 1000 mm (39.4 in). at it does not exceed the limit of 1000 mm (39.4 in).

The maximum tilt i Adjust the tilt so th at it does not exceed the limit of 1000 m If the maximum tilt is exceeded, excessiv e force will be bro ught to bear on all par ts, and this will damage the machine According to the operation of the bla de control lever, the following tilt amount can b e obtained: mm (22.5 in) or more m (22.5 in) or more uired, do as follows. Right side: 570 mm (22.5 in) or mor Left side: 570 m m (22.5 in) or more If more tilt is req uired, do as follows. Use bar handle ( 2) installed to the le ft brace to turn brace (1) and change the lengt h (l) of the brace. T his makes it pos sible to obtain a maximum tilt o f 1000 mm (39.4 in) .

nts is 1460 mm (57.5 in) Standard dist ance (l) between joi nts is 1460 mm ADJUSTING SHIM IN BLADE CYLINDER CAP Set the standard shim adjustment in t he blade cylinde r cap to 4 mm (0.16 in). o balance the wear of the cap and the ball at the rod. Remove shims t o balance the wear of the cap and t end of the piston The proper clear ance to be maintain ed with the shim s is 0.2 to 0.5 mm (0.008 to 0.0 2 in).