. OPERATION OPERATION ADJUSTING RIPPER 3 - 131 ADJUSTING DIGGING DEPTH There are mounting holes in the shank to chose to match t he ripping depth. Normally, use the bottom hole, b particularly deep ripping is ne When a giant ripper is inst For details, see "METHOD OF OPERATING PIN PULLE R (PAGE 3-123)". (Machines equipped with mu Place a pointed object o hammer to remove from Remove pin (2) and chan ge the position of the shank h Insert pin (1) partially by hand then knock it in with a ha mmer. The pin is made of on then knock it in with a REPLACING POINT AND PRO TECTOR rotector and point installed to the tip To protect the shank, if the p worn, replace them.
are Place a pin remover on the p in marked by the arrow, then h it with a h ammer to remove from th e opposite side. REMARK Th e pin is a unitized type, so insert the pin partially by hand , then knock it in fully with a hamm er.