Komatsu — INSTALLATION OF CAB

. OPERATION TRANSPORTATION installing the cab again. 3 - 137 REMOVAL OF CAB ) (If equipped) (Machine equipped with cab If it is necessary to remove the cab for transportation, disconnect the ng, and washer motor wiring before before 1. Pull the grommet portion machine cover, then rem 2. Disconnect 4 washer ho 4-pin plug x 1) from the After removing, cover prevent any dirt or du Before removing the the cab and each le etc.). Note the meas 1. Pull the grommet portion in towards the cab from the hole in the machine cover, then rem ove. ses and the wiring (single wires x 2, socket. 2.

Disconnect 4 washer ho 4-pin plug x 1) from the After removing, cover the washer hoses with a vinyl bag to st from entering. cab, measure the clearance between Before removing the ver (joystick and blade control urements to use as a standard lever, when INSTALLATION OF CA B ) (If equipped) pposite order to removal. disconnected. top of the floor frame. floor frame, then install bolts and U). n fully. Screw them in 3 or 4 turns. s (N) - (U) fully. (U), (Q), (R), (O), (T), (P), (S). (M), completely. (Machine equipped with cab Install the cab parts in the o Connect all parts that were 1. 2. 3. 4. 1. Lower the cab slowly on 2.

Align the cab with the washers in holes (A) - ( Do not screw the bolts i n fully. Screw them in 3 or 4 turns. 3. Tighten the bolts in hole Tighten in the order (N), 4. Tighten the bolts, (A) to If there are any unclear points about removing or installing the cab, please contact you r Komatsu distributor.