. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR IN HYDRAULIC SYSTEM 4 - 44 BLEED AIR FROM HEAD END OF RIGHT PITCH CYLI (DUAL TILT DOZE Bleed t he air if the w ork equipment has been remov 1. Raise the blade and run the engine at low idling 2. Operate the left and right tilt 5 to 10 times to ble ed the air from the tilt circuit. 3. Operate the for ward and rear pitch 5 to 10 time s to bleed the air from the bottom end of the righ t cylinder. 4.
Set the left and r ight cylinders at the neutral posit ion, then carry out the following operations 5 - 10 times to bleed the air from the head end of the right pitch cylin (1) Forward pitc h → (2) Left tilt → (3) Right tilt → See "OPERATIONS AND CHECKS AFTER STAR TING ENGINE (PAGE 3-94)". Since t he engine m ust be started and the blade mu st be operated, see OPERATION NOTICE If the engine is run at h igh speed immediately after startup or a cylinder is pushed up to it s stroke end, air take n inside the cylinder may cause damage to 1.
Bleeding air fro 1) Run the eng ine at low idle, and extend and retract each cylinder 4 to 5 times, taking car e tha t a cylinder is not moved t o the end of its stroke. (Stop the cylinder approx. 100 mm (3.9 in) short of it s stroke end) 2) Next, opera te each cylinder 3 to 4 times to t 3) Finally, oper ate each cylinder 4 to 5 times to the end of its stroke to c ompletel y remove the air. CHECK ELECTRICAL INTAKE AIR HEATER Check before the co ld season starts (once a year). Remove the electric heater from the engine intake manifold and check for wir e disconnections and dirt clinging to it When checking and installing the electric heater, re place its gasket with a ne w one.