Komatsu — LUBRICATING

. MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE LUBRICATING 4 - 47 1. Lower the work eq uipment to the ground, then stop the engine. 2. Using a grease pu mp, pump in grease through the grease 3. After greasing, wip e off any old grease that wa s pushed out.

(1) Blade lift cylinder s upport yoke (4 places) REMARK These are at the front and rear of the left and right cylinders (2) Blade lift cylinder s upport shaft (2 places) (3) (4) Blade arm ball joint Brace screw (2 plac (5) Ripper tilt cylinder b ottom pin (2 places) (6) Ripper lift cylinder b ottom pin (2 places) (7) Ripper tilt cylinder r od end pin (2 places (8) Ripper lift cylinder r od end pin (2 places (9) Ripper arm pin (fro nt) (2 places) ar) (2 places) (10)Ripper arm pin (re