.
ATTACHMENTS, OPTIONS SHOE SLIP CONTROL Mode Abnormality When shoe slip occurs, it is impossible to throttle power Even when there is shoe slippage, it is impossible to control After slippage stops, it takes a long time for power to recover It becomes difficult to break rock by operating lever to TILT or RAISE Travel speed increases when shank is inserted Travel speed is slow and drawbar pull is lacking No sense of control, engine stays at full or partial Chassis flies when starting ripping Shoe slip control 6 - 21 IF MODE SELECTION SYSTEM FLASHES If the caution lamp f lashes, or it become s impossible to control decelerato r p edal, s top operation check distributor for repairs In addition to the above problems, if an y o f the problems in the table below occur, there is probably an abnormality in the work equipmen t lever switch, transmission speed r ange sensor, or other part, so please contac t your Komatsu distributor for repairs speed then fuel control Operation Ripping