Kenworth — Kenworth T170 T270 T370 and Hybrid 2011 Body Builders Manual

Section 6 Body Mounting Hole Location Guidelines Holes must be located from the flange as indicated in Figure 6–7. They must be no closer than 2 inches (50 mm) to each other. CAUTION: Any unused holes must have the correct size bolts installed and torqued properly. Failure to do so can cause the frame rails to crack around the holes. Note: If your design permits placement of body mounting brackets at crossmember locations, you can use the crossmember gusset bolt holes for body mount- ing. See Figure 6-8 BODY MOUNTING USING U–BOLTS Spacers If the body is mounted to the frame with U–bolts, use a hardwood sill (minimum 0.

5 inch (12 mm) thick) between the frame rail and body frame to protect the top surface of the rail flange. WARNING: Do not allow the frame rails or flanges to deform when tightening the U–bolts. It will weaken the frame and could cause an accident. Use suitable spacers made of steel or hardwood on the inside of the frame rail to prevent collapse of the frame flanges. Use a hardwood spacer between the bottom flange and the U–bolt to prevent the U–bolt from notching the frame flange. See Figure 6–8. Body Structure U-Bolt Wood Sill 0. 5 (12) Minimum Truck Frame U-Bolt Spacer (Hardwood) Frame Rail Spacer (Fabricated Steel or Hardwood) FIGURE 6-7.

Acceptable U-Bolt Mounting with Wood and Fabricated Spacers [inch mm)] Do not allow spacers and other body mounting parts to interfere with brake lines, fuel lines, or wiring harnesses routed inside the frame rail. Crimped or damaged brake lines, fuel lines, or wiring could result in loss of braking, fuel leaks, electrical overload or a fire. Carefully inspect the installation to ensure adequate clearances for air brake lines, fuel lines, and wiring. See Figure 6–9. WARNING: CAUTION: Mount U–bolts so they do not chafe on frame rail. Failure to do so could result in premature wear of the U-bolt or frame rail and cause an accident. 6-4 12/11