Kenworth — Kenworth T170 T270 T370 and Hybrid 2011 Body Builders Manual

Section 7 Frame Modifications FRAME MODIFICATIONS Introduction The T170/T270/T370 offers multiple wheelbase configurations from the factory. So, in most cases frame modifications to produce a particular wheelbase should not be necessary. . However, some installations may require slight modifications, while other installations will require extensive modifications. For example an existing dealer stock chassis may need to have the wheelbase changed to better fit a customer’s applica- tion. The modifications may be as simple as shortening or lengthening the frame cutoff, or they may be as complex as changing the wheelbase.

Location and Hole Pattern DRILLING RAILS If holes need to be drilled to attach anything to the rail, see SECTION 6 “BODY MOUNTING” for more information. Follow the general spacing and hole location guidelines on Page 6–4, Figure 6–7. WARNING: When mounting a body to the chassis, DO NOT drill holes in the upper or lower flange of the frame rail. If the frame rail flanges are modified or dam- aged, the rail could fail prematurely and cause an accident. Mount the body using body mounting brackets or U–bolts. WARNING: Do not drill new holes any closer than 2 inches (50 mm) to existing holes.

Frame drilling affects the strength of the rails and if not done properly can cause the frame rails to fail and cause an accident. CAUTION: An appropriately sized bolt and nut must be installed and torqued properly in all unused frame holes. Failure to do so could result in frame crack initiation around the hole. CAUTION: Use care when drilling the frame web so the wires and air lines routed inside the rail are not damaged. Failure to do so could lead to equipment damage and cause an inoperable electrical or air system circuit. CAUTION: Never use a torch to make holes in the rail. Use the appropriate diameter drill bit.

Heat from a torch will affect the material properties of the frame rail and could result in frame rail cracks. CAUTION: Hole diameter should not exceed the bolt diameter by more than .060 inches (1.5 mm). Oversized holes could result in excessive frame wear around the hole. Hole pattern dimensions for crossmember designs are illustrated in Page 6–5, Figure 6–8. Hole diameter should not exceed the bolt diameter by more than . 060 inches (1. 5 mm). 7-1 12/11